Motorola Solutions WiNG 5.2.6 Reference Manual page 199

Figure 5-75 Profile Overrides - Virtual Interfaces Basic Configuration screen
The Basic Configuration screen displays by default regardless of a whether a new Virtual Interface is being created or
an existing one is being modified.
9. If creating a new Virtual Interface, use the spinner control to define a numeric ID between 1 - 4094.
10. Define or override the following parameters from within the Properties field:
Description
Admin Status
11. Set or override the following network information from within the IP Addresses field:
Enable Zero
Configuration
Primary IP Address
Use DHCP to Obtain IP
Provide or edit a description (up to 64 characters) for the Virtual Interface that
helps differentiate it from others with similar configurations.
Either select the Disabled or Enabled radio button to define this interface's
current status within the network. When set to Enabled, the Virtual Interface
is operational and available. The default value is disabled.
The access point can use Zero Config for IP assignments on an individual
virtual interface basis. Select Primary to use Zero Config as the designated
means of providing an IP address, this eliminates the means to assign one
manually. Selecting Secondary is preferred when wanting the option to either
use Zero Config or manual assignments. None is the default setting.
Define the IP address for the VLAN associated Virtual Interface.
Select this option to allow DHCP to provide the IP address for the Virtual
Interface. Selecting this option disables the Primary IP address field. AP-6532,
AP-7131, AP-7161 and AP-8132 models have on onboard DHCP server
resources, while AP-6511 and AP-6521 models do not.
Device Configuration 5 - 141