Motorola Solutions WiNG 5.2.6 Reference Manual page 349

3. Refer to the Basic Settings
Sensitivity
SMART RF Policy
Enable
Auto Assign Sensor
Interference
Recovery
Figure 6-32 Smart RF - Basic Configuration screen
field to enable a Smart RF policy and define its sensitivity and detector status.
Select a radio button corresponding to the desired Smart RF sensitivity.
Options include Low, Medium, High and Custom. Medium, is the default
setting. Select Custom sensitivity to enable Interference Recovery,
Coverage Hole Recovery and Neighbor Recovery as additional Smart RF
recovery options.
Select the Smart RF Policy Enable radio button to enable Smart RF for
immediate inclusion within a RF Domain. Smart RF is enabled by default.
Select the radio button to auto assign an access point sensor radio for
neighbor monitoring within the Smart RF supported network. This setting
is disabled by default.
Select the radio button to enable Interference Recovery when radio
interference is detected within the access point's radio coverage area.
When interference is detected, Smart RF first determines the power
increase needed based on the signal to noise ratio for a client (as seen by
the access point radio). If a client's signal to noise value is above the
threshold, the transmit power is increased until the signal to noise rate
falls below the threshold. This setting is enabled by default.
Wireless Configuration 6 - 87