Motorola Solutions WiNG 5.2.6 Reference Manual page 249

Port of SMTP
Sender E-mail Address
Recipient's E-mail
Address
Username for SMTP
Server
Password for SMTP
Server
8. Use the Configure drop-down menu within the
access point saves a configuration received from a Virtual Controller AP to flash memory. The configuration would then
be made available if the this access point reboots and the Virtual Controller AP is not reachable. Options include
Enabled, Disabled and secure.
9. Select OK to save the changes and overrides made to the profile's Management Settings. Select
the last saved configuration.
10. Select the Firmware tab from the Management menu.
If a non-standard SMTP port is used on the outgoing SMTP server check this
box and specify a port between 1 and 65,535 for the outgoing SMTP server
to use.
Specify the e-mail address that notification e-mails will be sent from. This
will be the from address on notification e-mails.
Specify the e-mail address(es) of recipients for email notifications.
Specify the username of the sender on the outgoing SMTP server. Many
SMTP servers require users to authenticate with an username and
password before sending e-mail through the server.
Specify the password associated with the username of the sender on the
outgoing SMTP server. Many SMTP servers require users to authenticate
with an username and password before sending e-mail through the server.
Persist Configuration Across Reloads
Device Configuration 5 - 191
field to define whether the
Reset to revert to