Motorola Solutions WiNG 5.2.6 Reference Manual page 356

6 - 94 WiNG 5.2.6 Access Point System Reference Guide
2.4 GHz Neighbor
Recovery Power
Threshold
17.Set the following
Dynamic Sample
Enabled
Dynamic Sample
Retries
Dynamic Sample
Threshold
18.Select OK
configuration.
Use the spinner control to set a value between -85 to -55 dBm the access
point's 2.4 GHz radio uses as a maximum power increase threshold if the
radio is required to increase its output power to compensate for a failed
radio within the access point's radio coverage area. The default value is
-70 dBm.
Dynamic Sample Recovery
Select this option to enable dynamic sampling. Dynamic sampling enables
an administrator to define how Smart RF adjustments are triggered by
locking retry and threshold values. This setting is disabled by default.
Use the spinner control to set the number of retries (1 - 10) before a power
change is allowed to compensate for a potential coverage hole. The
default setting is 3.
Use the spinner control to set the number of sample reports (1 - 30) used
before dynamic sampling is invoked for a potential power change
adjustment. The default setting is 5.
to update the Smart RF Neighbor Recovery settings. Select
parameters:
Reset to revert to the last saved