Motorola Solutions WiNG 5.2.6 Reference Manual page 444

9 - 6 WiNG 5.2.6 Access Point System Reference Guide
2. Select Access Control
3. Set the following parameters required for
Enable Telnet
Telnet Port
from the list of Management Policy options in the upper, left-hand, side of the UI.
Figure 9-3 Management Policy Access Control screen
Telnet access:
Select the checkbox to enable Telnet device access. Telnet provides a
command line interface to a remote host over TCP. Telnet provides no
encryption, but it does provide a measure of authentication. Telnet access
is disabled by default.
Set the port on which Telnet connections are made (1 - 65,535). The default
port is 23. Change this value using the spinner control or by entering the
port number in the field.