Motorola Solutions WiNG 5.2.6 Reference Manual page 117

MAC Outbound Tunnel
ACL
NOTE: If creating a mesh connection between two access points in Standalone AP
mode, Tunnel must be selected as the Bridging Mode to successfully create the mesh link
between the two access points.
9. Define the following Layer 2 Firewall
Trust ARP Response
Trust DHCP Responses
Enable Edge VLAN
Mode
10. Select the OK button located at the bottom right of the screen to save the changes. Select
saved configuration.
Select a MAC Outbound Tunnel ACL for outbound traffic from the drop-down
menu. If an appropriate outbound MAC ACL is not available click the create
button to make a new one.
parameters:
Select the radio button to use trusted ARP packets to update the DHCP Snoop
Table to prevent IP spoof and arp-cache poisoning attacks. This feature is
disabled by default.
Select the radio button to use DHCP packets from a DHCP server as trusted
and permissible within the network. DHCP packets are used to update the
DHCP Snoop Table to prevent IP spoof attacks. This feature is disabled by
default.
Select the radio button to enable edge VLAN mode. When selected, the IP
address in the VLAN is not used for normal operations, as its now designated
to isolate devices and prevent connectivity. This feature is enabled by
default.
Device Configuration 5 - 59
Reset to revert to the last