Motorola Solutions WiNG 5.2.6 Reference Manual page 357

19.Select the Interference Recovery
Figure 6-35 Smart RF Recovery screen - Interference Recovery tab
20.Set the following Interference Recovery
Interference
Noise
Channel Hold Time
Client Threshold
tab.
parameters:
Select the radio button to allow Smart RF to scan for excess interference
from supported radio devices. WLANs are susceptible to sources of
interference, such as neighboring radios, cordless phones, microwave
ovens and Bluetooth devices. When interference for WiFi sources is
detected, Smart RF supported devices can change the channel and move
to a cleaner channel. This feature is enabled by default.
Select the radio button to allow Smart RF to scan for excess noise from
WiFi devices. When detected, Smart RF supported access points can
change their channel and move to a cleaner channel. This feature is
enabled by default.
Defines the minimum time between channel changes during neighbor
recovery. Set the time in either Seconds (0 - 86,400), Minutes (0 - 1,440) or
Hours (0 - 24) or Days (0 - 1). The default setting is 1 hour.
Use the spinner to set a client threshold between 1 - 255. If the threshold
defined number of clients are connected to a radio, the radio does not
change its channel, even though required, based on the interference
recovery determination made by the smart master. The default setting is
50.
Wireless Configuration 6 - 95