Motorola Solutions WiNG 5.2.6 Reference Manual page 182

5 - 124 WiNG 5.2.6 Access Point System Reference Guide
7. Select + Add Row
server resources used it obtain system time. Set the following parameters to define the NTP configuration:
AutoKey
Key
Prefer
Server IP
Version
8. Select OK
the last saved configuration.
Figure 5-68 Profile Overrides - General screen
NOTE: A blue override icon (to the left of a parameter) defines the parameter as having
an override applied. To remove an override, go to the Basic Configuration screen's Device
Overrides field and select Clear Overrides. This will remove all overrides from the device.
below the Network Time Protocol (NTP) table to define (or override) the configurations of NTP
Select the radio button to enable an autokey configuration for the NTP
resource. This is a key randomly generated for use between the access point
and its NTP resource. The default setting is disabled.
If an autokey is not being utilized, you must manually enter a 64 character
maximum key shared for interoperation.
Select the radio button to designate this particular NTP resource as preferred.
If designating multiple NTP resources, preferred resources will be given first
opportunity to connect to and provide NTP calibration.
Set the IP address of each server added as a potential NTP resource.
Use the spinner control to specify the version number used by this NTP server
resource. The default setting is 0.
to save the changes and overrides made to the general profile configuration. Select Reset to revert to