Configuring Client Load Balancing - Motorola Solutions WiNG 5.2.6 Reference Manual

6 - 38 WiNG 5.2.6 Access Point System Reference Guide

6.1.6 Configuring Client Load Balancing

Client load balance settings can be defined generically to both the 2.4 and 5 GHz bands and specifically to either of
the 2.4 or 5 GHz bands.
To configure client load balancing settings on an access point managed WLAN:
1. Select Configuration
2. Select the
3. Select Client Load
4. Set the following
Enforce Client Load
Balancing
Band Discovery
Interval
Capability Ageout Time
> Wireless > Wireless LANs
Add button to create an additional WLAN, or
Balancing.
Figure 6-14 WLAN Client Load Balancing screen
Load Balance Settings
Select the radio button to enforce a client load balance distribution on this
WLAN. AP-6532, AP-7131, AP-7161 and AP-8132 model access points can
support 256 clients per access point. An AP-6511 or AP-6521 model can
support up to 128 clients per access point. Therefore, client load balancing
can be enforced for the WLAN as more and more WLANs are deployed.
This setting is Enabled by default.
Define a value in either Seconds (0 and 10,000), Minutes (0 -166) or Hours
(0 -2) the access point uses to discover a client's band capabilities before
associating. The default is 24 seconds.
Define a value in either Seconds (0 and 10,000), Minutes (0 -166) or Hours
(0 -2) to ageout a client's capabilities from the access point's internal table.
The default is 24 seconds.
to display a high-level display of the existing WLANs.
Edit to modify the properties of an existing WLAN.
generic to both the 2.4 and 5 GHz bands: