Motorola Solutions WiNG 5.2.6 Reference Manual page 100

5 - 42 WiNG 5.2.6 Access Point System Reference Guide
22. Set the following
wireless clients:
Non-Unicast
Transmit Rate
Non-Unicast
Forwarding
23. Refer to the
Host for Redirected
Packets
Channel to Capture
Packets
24. Refer to the
RIFS Mode
STBC Mode
Non-Unicast Traffic
Use the Select drop-down menu to launch a sub screen to define the data rate
broadcast and multicast frames are transmitted. Seven different rates are
available if the not using the same rate for each BSSID, each with a separate
menu.
Define whether client broadcast and multicast packets should always follow
DTIM, or only follow DTIM when using Power Save Aware mode. The default
setting is Follow DTIM.
Sniffer Redirect (Packet Capture)
If packets are re-directed from an access point radio, define an IP address of a
resource (additional host system) used to capture the re- directed packets. This
address is the numerical (non DNS) address of the host used to capture the
re-directed packets.
Use the drop-down menu to specify the channel used to capture re-directed
packets. The default value is channel 1.
Miscellaneous field to define the following RIFS, STBC and Beanforming settings
Define a RIFS Mode using the drop-down menu. The RIFS mode determines
whether interframe spacing is applied to transmitted or received packets, both
or none. The default mode is Transmit and Receive. Consider setting this value
to None for high priority traffic to reduce packet delay.
Use the drop-down menu to specify the radio's Space Time Block Coding
(STBC) mode. STBC is a pre-transmission encoding scheme providing an
improved SNR ratio (even at a single RF receiver). STBC transmits multiple data
stream copies across multiple antennas. The receiver combines the multiple
copies into one to retrieve data from the signal. These transmitted data
versions provide redundancy to increase the odds of receiving data streams
with a good data decode (especially in noisy environments). Select either None
or Transmit Only. The default setting is None.
values for the profile's supported access point radio and its connected
field to define the radio's captured packet configuration.