Creating And Deleting A Dynamic Aggregate Group; Creating A Dynamic Aggregate Group; Deleting A Dynamic Aggregate Group - Alcatel OmniSwitch 6624 Network Configuration Manual

Configuring Dynamic Link Aggregation

Creating and Deleting a Dynamic Aggregate Group

The following subsections describe how to create and delete dynamic aggregate groups with the
linkagg size command.

Creating a Dynamic Aggregate Group

To configure a dynamic aggregate group enter lacp linkagg, followed by the user-configured dynamic
aggregate number (which can be from 0 to 29), size, and the maximum number of links that will belong to
this dynamic aggregate group, which can be 2, 4, or 8 on a single switch or 2, 4, 8, or 16 on a stack. For
example, to configure dynamic aggregate group 2 consisting of eight (8) links enter:
-> lacp linkagg 2 size 8
You can create up to 4 link aggregation (both dynamic and static) groups on a single OmniSwitch 6624 or
6600-U24 switch, up to 8 link aggregation groups on a single 6648 switch, and up to 30 link aggregation
groups per stack.
In addition, you can also specify optional parameters shown in the table below. These parameters must be
entered after size and the user-specified number of links.
lacp linkagg size keywords
name
actor system priority
partner system priority
For example, to create a dynamic aggregate group with aggregate number 3 consisting of two ports called
"aggregate1" that is administratively disabled, enter:
-> lacp linkagg 3 size 2 name aggregate1 admin state disable
Note. The optional keywords for this command may be entered in any order as long as they are entered
after size and the user-specified number of links.

Deleting a Dynamic Aggregate Group

To remove a dynamic aggregation group configuration from a switch use the no form of the
size command by entering no lacp linkagg followed by its dynamic aggregate group number.
For example, to delete dynamic aggregate group 2 from a switch's configuration you would enter:
-> no lacp linkagg 2
Note. You cannot delete a dynamic aggregate group if it has any attached ports. To remove attached ports
you must disable the dynamic aggregate group with the
described in "Disabling a Dynamic Aggregate Group" on page
OmniSwitch 6624/6648 Network Configuration Guide
admin state enable
admin state disable
actor system id
lacp linkagg admin state
April 2004
Configuring Dynamic Link Aggregate Groups
partner admin key
actor admin key
partner system id
command, which is
11-18.
lacp
lacp linkagg
page 11-11