Configuring The Radius Client - Alcatel OmniSwitch 6624 Network Configuration Manual

RADIUS Servers
The following table lists the VSAs supported for RADIUS accounting servers. The attributes in the
radius.ini file may be modified if necessary.
Num. Accounting VSA
1 Alcatel-Auth-Group
2 Alcatel-Slot-Port
4 Alcatel-Client-IP-Addr
5 Alcatel-Group-Desc

Configuring the RADIUS Client

Use the aaa radius-server
RADIUS server keywords
key
host
retransmit
When creating a new server, at least one host name or IP address (specified by the host keyword) is
required as well as the shared secret (specified by the key keyword).
In this example, the server name is rad1, the host address is 10.10.2.1, the backup address is 10.10.3.5,
and the shared secret is amadeus. Note that the shared secret must be configured exactly the same as on
the server.
-> aaa radius-server rad1 host 10.10.2.1 10.10.3.5 key amadeus
To modify a RADIUS server, enter the server name and the desired parameter to be modified.
-> aaa radius-server rad1 key mozart
If you are modifying the server and have just entered the aaa radius-server command to create or modify
the server, you can use command prefix recognition. For example:
-> aaa radius-server rad1 retransmit 5
-> timeout 5
For information about server defaults, see
To remove a RADIUS server, use the no form of the command:
-> no aaa radius-server rad1
Note that only one server may be deleted at a time.
page 17-14
Type
integer
string
dotted
decimal
string
command to configure RADIUS parameters on the switch.
timeout
auth-port
acct-port
"Server Defaults" on page
OmniSwitch 6624/6648 Network Configuration Guide
Managing Authentication Servers
Description
The authenticated VLAN number. The only protocol
associated with this attribute is Ethernet II. If other
protocols are required, use the protocol attribute
instead.
Slot(s)/port(s) valid for the user.
The IP address used for Telnet only.
Description of the authenticated VLAN.
17-3.
April 2004