Remote Monitoring (RMON)
RMON Probe Defaults
The following table shows Remote Network Monitoring default values.
Global RMON Probe Defaults
Parameter Description
RMON Probe Configuration
Quick Steps for Enabling/Disabling RMON Probes
1
Enable an inactive (or disable an active) RMON probe, where necessary. You can also enable or
disable all probes of a particular flavor, if desired. For example:
-> rmon probes stats 4005 enable
-> rmon probes history disable
2
To verify the RMON probe configuration, enter the
for the type of probe. For example, to display the statistics probes, enter the following:
-> show rmon probes stats
The display is similar to the one shown below:
Entry
Slot/Port
-----+-----------+-----------+----------+---------------+---------------------
4001
4/1
4008
4/8
4005
4/5
3
To view statistics for a particular RMON probe, enter the show rmon probes command, with the
keyword for the type of probe, followed by the entry number for the desired RMON probe. For example:
-> show rmon probes 4005
The display will appear similar to the one shown below:
Probe's Owner: Hawk Switch Auto Probe on Slot 4, Port 5
Entry 4005
Flavor = Ethernet, Status = Active
Time = 0 hrs 03 mins,
System Resources (bytes) = 275
For more information about these commands, see
"Displaying Statistics for a Particular RMON Probe" on page 24-20
in the OmniSwitch CLI Reference Guide.
page 24-6
CLI Command
rmon probes
Flavor
Status
Ethernet
Active
Ethernet
Active
Ethernet
Active
"Displaying a List of RMON Probes" on page
OmniSwitch 6624/6648 Network Configuration Guide
Default Value/Comments
No RMON probes configured.
show rmon probes
command with the keyword
Duration
System Resources
00:25:00
275 bytes
00:25:00
275 bytes
00:03:03
275 bytes
or the "RMON Commands" chapter
Diagnosing Switch Problems
24-19,
April 2004