Configuring QoS
To display only policy rules that are active (enabled and applied) on the switch, use the show active
policy rule command. For example:
-> show active policy rule
mac1
Cnd/Act:
In this example, the rule my_rule does not display because it is inactive. Rules are inactive if they are
administratively disabled through the policy rule command, or if the rule cannot be enforced by the
current hardware. Although my_rule5 is administratively active, it is still pending and not yet applied to
the configuration. Only mac1 is displayed here because it is active on the switch.
See the OmniSwitch CLI Reference Guide for more information about the output of these commands.
OmniSwitch 6624/6648 Network Configuration Guide
Policy
From Prec
cli
dmac1 -> pri2
Enab Inact Refl Log Save
0
Yes
No
No
April 2004
Creating Policies
Matches
No
Yes
0
page 21-31