Modifying The Actor Port System Id - Alcatel OmniSwitch 6624 Network Configuration Manual

Configuring Dynamic Link Aggregation
lacp agg actor admin state
Keyword
expire
Note. Specifying none removes all administrative states from the LACPDU configuration. For example:
-> lacp agg 5/49 actor admin state none
For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate actor port 49 in slot 5 you
would enter:
-> lacp agg 5/49 actor admin state active aggregate
As an option you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate actor port 49 in
slot 5 and document that the port is a Gigabit Ethernet port you would enter:
-> lacp agg gigaethernet 5/49 actor admin state active aggregate
Restoring Actor Port Administrative State Values
To restore LACPDU bit settings to their default values use
entering enter no before the active, timeout, and aggregate keywords.
For example, to restore bits 0 (active) and 2 (aggregate) to their default settings on dynamic aggregate
actor port 2 in slot 5 you would enter:
-> lacp agg 5/2 actor admin state no active no aggregate
Note. Since individual bits with the LACPDU frame are set with the lacp agg actor admin state
command you can set some bits on and restore other bits within the same command. For example, if you
wanted to restore bit 2 (aggregate) to its default settings and set bit 0 (active) on dynamic aggregate actor
port 49 in slot 5 you would enter:
-> lacp agg 5/49 actor admin state active no aggregate

Modifying the Actor Port System ID

By default, the actor port system ID (i.e., the MAC address used as the system ID on dynamic aggregate
actor ports) is 00:00:00:00:00:00. The following subsections describe how to configure a user-specified
value and how to restore the value to its default value with the
Configuring an Actor Port System ID
You can configure the actor port system ID by entering lacp agg, the slot number, a slash (/), the port
number, actor system id, and the user specified actor port system ID (i.e., MAC address) in the hexadeci-
mal format of xx:xx:xx:xx:xx:xx.
OmniSwitch 6624/6648 Network Configuration Guide
Modifying Dynamic Link Aggregate Group Parameters
Definition
Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 7) is set by the system, the actor can-
not receive LACPDU frames.
lacp agg actor admin state
April 2004
lacp agg actor system id
command by
command.
page 11-23