Modifying IPMS Parameters
Modifying the Query Interval
The default IPMS query interval (i.e., the time between IGMP queries) is 125 seconds. The following
subsections describe how to configure a user-specified query interval value and how to restore it with the
ip multicast query-interval
Configuring the Query Interval
You can modify the query interval from 0 to 4294967295 seconds by entering
interval
followed by the new value. For example, to set the query interval to 60 seconds you would enter:
-> ip multicast query-interval 60
Restoring the Query Interval
To restore the query interval to its default (i.e., 125 seconds) value you use the no form of the
ip multicast query-interval
-> ip multicast no query-interval
Modifying the Membership Timeout
The default IPMS membership timeout (i.e., the time the switch will wait for an IGMP report before it
drops a member from a multicast group) is 260 seconds. The following subsections describe how to
configure a user-specified membership timeout value and how to restore it with the
membership-timeout
Configuring the Membership Timeout
You can modify the IPMS membership timeout from 0 to 4294967295 seconds by entering
membership-timeout
100 seconds you would enter:
-> ip multicast membership-timeout 100
Restoring the Membership Timeout
To restore the membership timeout to its default (i.e., 260 seconds) value you use the no form of the
multicast membership-timeout
-> ip multicast no membership-timeout
page 23-10
command.
command by entering:
command.
followed by the new value. For example, to set the membership timeout value to
command by entering:
OmniSwitch 6624/6648 Network Configuration Guide
Configuring IP Multicast Switching
ip multicast query-
ip multicast
ip multicast
April 2004
ip