Configuring The Igmp Proxy Version; Configuring Igmp Proxy Version 3; Configuring Igmp Proxy Version 2; Configuring And Removing A Static Neighbor - Alcatel OmniSwitch 6624 Network Configuration Manual

Configuring IPMS on a Switch

Configuring the IGMP Proxy Version

By default, the version of Internet Group Management Protocol (IGMP) membership is Version 2. The
following subsections describe how to configure the proxy version as Version 2 or Version 3 with the
multicast igmp-proxy-version

Configuring IGMP Proxy Version 3

To change the IGMP proxy version to Version 3 (IGMPv3) use the
command by entering:
-> ip multicast igmp-proxy-version v3

Configuring IGMP Proxy Version 2

To restore the IGMP proxy version to Version 2 (IGMPv2) use the
command by either use the no form of the command by entering:
-> ip multicast no igmp-proxy-version
Or, as an alternative enter:
-> ip multicast igmp-proxy-version v2
To restore the IGMP proxy version to Version 2.

Configuring and Removing a Static Neighbor

IPMS static neighbor ports receive all multicast streams on the designated VLAN and also receive IGMP
reports for the VLAN. The following subsections describe how to configure and remove a static neighbor
port with the ip multicast static-neighbor

Configuring a Static Neighbor

You can configure a port as an IPMS static neighbor port by entering
followed by the VLAN number (which must be between 0 and 4095), a space, the slot number of the port,
a slash (/), and the port number.
For example, to configure port 4 in slot 10 with designated VLAN 2 as a static neighbor you would enter:
-> ip multicast static-neighbor 2 4/10
By default, the version of IGMP that will be used is Version 2. As an option, you can also specify the
version of IGMP (either version 2 or Version 3) by entering ip multicast static-neighbor followed by the
VLAN number (which must be between 0 and 4095), a space, the slot number of the port, a slash (/), the
port number, and either v2 or v3.
For example, to configure port 4 in slot 10 with designated VLAN 2 as a static neighbor that uses IGMP
Version 3 you would enter:
-> ip multicast static-neighbor 2 4/10 v3
page 23-6
command.
command.
OmniSwitch 6624/6648 Network Configuration Guide
Configuring IP Multicast Switching
ip multicast igmp-proxy-version
ip multicast igmp-proxy-version
ip multicast static-neighbor
ip
April 2004