How To Define A Mac-Port Binding Rule; How To Define A Mac-Ip Address Binding Rule; How To Define An Ip-Port Binding Rule - Alcatel OmniSwitch 6624 Network Configuration Manual
Hide thumbs
Also See for OmniSwitch 6624:
- Troubleshooting manual (614 pages) ,
- Management manual (264 pages) ,
- Network configuration manual (654 pages)
Table of Contents
Advertisement
Configuring VLAN Rule Definitions
How to Define a MAC-Port Binding Rule
To define a MAC-port binding rule, enter vlan followed by an existing VLAN ID then binding mac-port
followed by a valid MAC address and a slot/port designation. For example, the following command
defines a MAC-port binding rule for VLAN 1500:
-> vlan 1500 binding mac-port 00:02:9a:3e:f1:06 6/10
In this example, frames received on mobile port 6/10 must contain a source MAC address of
00:02:9a:3e:f1:06 to qualify for dynamic assignment to VLAN 1500.
Use the no form of the
is only necessary to enter the rule's MAC address parameter value to identify which rule to remove.
-> vlan 1500 no binding mac-port 00:02:9a:3e:f1:06
Note that this binding rule type is also supported on AVLANs. See
cated VLANs,"
for more information.
How to Define a MAC-IP Address Binding Rule
To define a MAC-IP address binding rule, enter vlan followed by an existing VLAN ID then
binding mac-ip followed by a valid IP subnet address. For example, the following command defines a
MAC-IP binding rule for VLAN 1501:
-> vlan 1501 binding mac-ip 00:02:9a:3e:f1:07 172.16.6.3
In this example, frames received on any mobile port must contain a source MAC address of
00:02:9a:3e:f1:07 and a source IP subnet address of 172.16.6.3 to qualify for dynamic assignment to
VLAN 1501.
Use the no form of the
only necessary to enter the rule's MAC address parameter value to identify which rule to remove.
-> vlan 1500 no binding mac-port 00:02:9a:3e:f1:07
How to Define an IP-Port Binding Rule
To define a IP-port binding rule, enter vlan followed by an existing VLAN ID then binding ip-port
followed by a valid IP subnet address and a slot/port designation. For example, the following command
defines an IP-port binding rule for VLAN 1502:
-> vlan 1502 binding ip-port 172.16.6.4 5/12
In this example, frames received on mobile port 5/12 must contain a source IP subnet address of
172.16.6.4 to qualify for dynamic assignment to VLAN 1502.
Use the no form of the
only necessary to enter the rule's IP subnet address parameter value to identify which rule to remove.
-> vlan 1502 no binding ip-port 172.16.6.4
Note that this binding rule type is also supported on AVLANs. See
cated VLANs,"
for more information.
page 7-16
vlan binding mac-port
command to remove a MAC-port binding rule. Note that it
vlan binding mac-ip
command to remove a MAC-IP binding rule. Note that it is
vlan binding ip-port
command to remove an IP-port binding rule. Note that it is
OmniSwitch 6624/6648 Network Configuration Guide
Defining VLAN Rules
Chapter 18, "Configuring Authenti-
Chapter 18, "Configuring Authenti-
April 2004
Advertisement
Table of Contents
