Alcatel OmniSwitch 6624 Network Configuration Manual page 172

Application Example
The following steps apply to Stack 2. They will attach port 2/1 to VLAN 2, and set the port to accept
802.1Q tagged traffic only:
1 Create VLAN 2 by entering vlan 2 as shown below (VLAN 1 is the default VLAN for the switch):
-> vlan 2
2 Set port 2/1 as a tagged port and assign it to VLAN 2 by entering the following:
-> vlan 2 802.1q 2/1
3 Set port 2/1 to accept only tagged traffic by entering the following:
-> vlan 802.1q 2/1 frame type tagged
4
Check the configuration using the
-> show 802.1q 2/1
Acceptable Frame Type
Force Tag Internal
Tagged VLANS
-------------+-------------------------------------------------+
2
Connecting Stack 2 and Stack 3 Using 802.1Q
The following steps apply to Stack 2. They will attach ports 3/1 and 3/2 as link aggregation group 5 to
VLAN 3.
1 Configure static aggregate VLAN 5 by entering the following:
-> static linkagg 5 size 2
2
Assign ports 3/1 and 3/2 to static aggregate VLAN 5 by entering the following two commands:
-> static agg 3/1 agg num 5
-> static agg 3/2 agg num 5
3 Create VLAN 3 by entering the following:
-> vlan 3
4 Configure 802.1Q tagging with a tagging ID of 3 on link aggregation group 5 (on VLAN 3) by enter-
ing vlan 3 802.1q 5 as shown below:
-> vlan 3 802.1q 5
5
Check the configuration using the
-> show 802.1q 5
Tagged VLANS
-------------+-------------------------------------------------+
3
page 9-10
show 802.1q
: tagged only
:
Internal Description
TAG PORT 2/1 VLAN 2
show 802.1q
Internal Description
TAG AGGREGATE 5 VLAN 3
OmniSwitch 6624/6648 Network Configuration Guide
command, as follows:
on
command, as follows:
Configuring 802.1Q
April 2004