Ethernet Ports Overview; Omniswitch 6648 - Alcatel OmniSwitch 6624 Network Configuration Manual

Ethernet Ports Overview

Ethernet Ports Overview
This chapter describes the Ethernet software CLI commands used for configuring and monitoring your
switch's Ethernet port parameters. These commands allow you to handle administrative or port-related
requests to and from SNMP, the CLI or WebView.

OmniSwitch 6648

The OmniSwitch 6648 provides 48 10/100 Mbps ports and two expansion slots. The expansion slots are
empty by default. Optionally, they can hold either four Gigabit Ethernet ports or two Gigabit Ethernet
ports and two stacking connections. Port numbers 1 through 48 support both 10 Mbps Ethernet and 100
Mbps Fast Ethernet interfaces. Port numbers 49, 50, 51 and 52 support 1000 Mbps Gigabit Ethernet when
the Gigabit Ethernet modules are installed. For more information on Ethernet hardware configurations,
refer to the OmniSwitch 6600 Series Hardware Users Guide.
The OmniSwitch software supports the Gigabit Ethernet expansion modules listed in the table here.
Module
OS6600-GNI-C2
OS6600-GNI-U2
25
OmniSwitch 6648
TM
CONSOLE
26
1
OK1 PS1 PRI TEMP
OK2 PS2 SEC FAN SEL
2
10/100 Ethernet Ports 1 through 48
page 1-6
Description
2 port 1 Gbps Gigabit Ethernet copper uplink module. This module supports
1522 bytes if frame 802.1Q is tagged. Otherwise, 1518 bytes are supported.
2 port 1 Gbps Gigabit Ethernet fiber uplink module. This module supports 1522
bytes if frame 802.1Q is tagged. Otherwise, 1518 bytes are supported.
27 29 31 33 35 37 39
28 30 32 34 36 38 40
3 5 7 9 11 13 15
4 6 8 10 12 14 16
OmniSwitch 6624/6648 Network Configuration Guide
41 43 45 47
LINK/ACT
49
42 44 46
48
17 19 21 23 EXPANSION
18 20 22 24
Optional Stacking or Gigabit Ethernet Modules,
Ports 49, 50, 51, and 52
Configuring Ethernet Ports
LINK/ACT
EXPANSION/STACKING
5 0 5 1 5 2
LINK/ACT LINK/ACT
April 2004