Modifying The Partner Port Administrative Status; Modifying The Partner Port Priority - Alcatel OmniSwitch 6624 Network Configuration Manual

Modifying Dynamic Link Aggregate Group Parameters
Restoring the Partner Port System Priority
To remove a user-configured system priority from a dynamic aggregate group partner port's configuration
use the no form of the
number, a slash (/), the port number, and no partner admin system priority.
For example, to remove a user-configured system ID from dynamic aggregate partner port 3 in slot 4 you
would enter:
-> lacp agg 4/3 no partner admin system priority

Modifying the Partner Port Administrative Status

By default, the administrative status of a dynamic aggregate group partner port is 0. The following subsec-
tions describe how to configure a user-specified value and how to restore the value to its default value with
the lacp agg partner admin port
Configuring the Partner Port Administrative Status
You can configure the administrative status of a dynamic aggregate group partner port to a value ranging
from 0 to 65535 by entering lacp agg, the slot number, a slash (/), the port number, partner admin port,
and the user-specified partner port administrative status.
For example, to modify the administrative status of dynamic aggregate partner port 1 in slot 7 to 200 you
would enter:
-> lacp agg 7/1 partner admin port 200
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to modify the administrative status of dynamic aggregate partner port 1 in
slot 7 to 200 and document that the port is a Fast Ethernet port you would enter:
-> lacp agg fastethernet 7/1 partner admin port 200
Restoring the Partner Port Administrative Status
To remove a user-configured administrative status from a dynamic aggregate group partner port's configu-
ration use the no form of the
number, a slash (/), the port number, and no partner admin port.
For example, to remove a user-configured administrative status from dynamic aggregate partner port 1 in
slot 7 you would enter:
-> lacp agg 7/1 no partner admin port

Modifying the Partner Port Priority

The default partner port priority is 0. The following subsections describe how to configure a user-specified
value and how to restore the value to its default value with the
command.
Configuring the Partner Port Priority
To configure the partner port priority to a value ranging from 0 to 255 by entering lacp agg, the slot
number, a slash (/), the port number, partner admin port priority, and the user-specified partner port
priority.
page 11-30
lacp agg partner admin system priority
command.
lacp agg partner admin port
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
command by entering lacp agg, the slot
command by entering lacp agg, the slot
lacp agg partner admin port priority
April 2004