Condition Combinations - Alcatel OmniSwitch 6624 Network Configuration Manual

Condition Combinations

Condition Combinations
The CLI prevents you from configuring invalid condition combinations that are never allowed; however, it
does allow you to create combinations that are supported in some scenario. For example, you might
configure destination slot/port and destination interface type for the same condition. This is a valid combi-
nation, but will only be used to classify bridged traffic.
Note the following:
Layer 2 and Layer 3/4 conditions cannot be combined.
•
Source and destination parameters cannot be combined in Layer 2 conditions; source and destination
•
parameters may be combined in Layer 3/4 conditions.
Individual items and their corresponding groups cannot be combined in the same condition. For exam-
•
ple, a source IP address cannot be included in a condition with a source IP network group.
Use the policy condition combinations table as a guide when configuring policy conditions.
How to Use the Condition Combination Table. Each row represents items that may be combined; any
cavaets are listed in the Notes column.
For information about combining conditions with actions, see
page 21-7.
Policy Condition Combinations
Condition Combinations
source MAC address or MAC group
source VLAN
source slot/port or port group
source interface type
destination MAC address or MAC group
destination VLAN
destination slot/port or port group
destination interface type
source IP address or network group
destination IP address or network group
source TCP/UDP port
destination TCP/UDP port
IP protocol
source slot/port or port group
destination slot/port or port group
multicast IP address or network group
destination IP address or network group
destination MAC or MAC group
destination VLAN
destination slot/port or port group
destination interface type
802.1p
source slot/port or port group
source interface type
page 21-6
"Condition/Action Combinations" on
Supported When?
bridging only
bridging only
routing/bridging when qos classifyl3
bridged is enabled
multicast rules only
bridging
OmniSwitch 6624/6648 Network Configuration Guide
Configuring QoS
Notes
—
—
IP protocol must be specified if IP
port is specified generally with the
source ip port and/or desination ip
port keywords.
—
—
April 2004