Modifying The Dynamic Aggregate Group Partner Administrative Key; Modifying The Dynamic Aggregate Group Partner System Priority - Alcatel OmniSwitch 6624 Network Configuration Manual
Hide thumbs
Also See for OmniSwitch 6624:
- Troubleshooting manual (614 pages) ,
- Management manual (264 pages) ,
- Network configuration manual (654 pages)
Table of Contents
Advertisement
Modifying Dynamic Link Aggregate Group Parameters
Restoring the Dynamic Aggregate Group Actor System ID
To remove the user-configured actor switch system ID from a dynamic aggregate group's configuration
use the no form of the
dynamic aggregate group number and no actor system id.
For example, to remove the user-configured system ID from dynamic aggregate group 4 you would enter:
-> lacp linkagg 4 no actor system id
Modifying the Dynamic Aggregate Group Partner Administrative Key
By default, the dynamic aggregate group partner administrative key (i.e., the administrative key of the
partner switch) is 0. The following subsections describe how to configure a user-specified value and how
to restore the value to its default value with the
Configuring a Dynamic Aggregate Group Partner Administrative Key
You can modify the dynamic aggregate group partner administrative key to a value ranging from 0 to
65535 by entering lacp linkagg followed by the dynamic aggregate group number, partner admin key,
and the value for the administrative key, which can be 0 through 65535.
For example, to set the partner administrative key to 4 on dynamic aggregate group 4 you would enter:
-> lacp linkagg 4 partner admin key 10
Restoring the Dynamic Aggregate Group partner Administrative Key
To remove a partner administrative key from a dynamic aggregate group's configuration use the no form
of the lacp linkagg partner admin key command by entering lacp linkagg followed by the dynamic
aggregate group number, and no partner admin key.
For example, to remove the user-configured partner administrative key from dynamic aggregate group 4
you would enter:
-> lacp linkagg 4 no partner admin key
Modifying the Dynamic Aggregate Group Partner System Priority
By default, the dynamic aggregate group partner system priority is 0. The following subsections describe
how to configure a user-specified value and how to restore the value to its default value with the
lacp linkagg partner system priority
Configuring a Dynamic Aggregate Group Partner System Priority
You can modify the dynamic aggregate group partner system priority to a value ranging from 0 to 65535
by entering lacp linkagg followed by the dynamic aggregate group number, partner system priority, and
the new priority value.
For example, to set the partner system priority on dynamic aggregate group 4 to 2000 you would enter:
-> lacp linkagg 4 partner system priority 2000
Restoring the Dynamic Aggregate Group Partner System Priority
To restore the dynamic aggregate group partner system priority to its default (i.e., 0) value use the no form
of the
lacp linkagg partner system priority
aggregate group number and no partner system priority.
page 11-20
lacp linkagg actor system id
command.
command by entering lacp linkagg followed by the dynamic
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
command by entering lacp linkagg followed by the
lacp linkagg partner admin key
command.
April 2004
Advertisement
Table of Contents
