Displaying Udp Information; Verifying The Ip Configuration - Alcatel OmniSwitch 6624 Network Configuration Manual

Verifying the IP Configuration

Displaying UDP Information

UDP is a secondary transport-layer protocol that uses IP for delivery. UDP is not connection-oriented and
does not provide reliable end-to-end delivery of datagrams. But some applications can safely use UDP to
send datagrams that do not require the extra overhead added by TCP. Use the
command to display UDP statistics. Use the
Verifying the IP Configuration
A summary of the show commands used for verifying the IP configuration is given here:
show ip interface
show ip route
show ip router database
show ip config
show ip protocols
show ip service
show arp
show icmp control
show ip dos config
show ip dos statistics
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
page 12-20
show udp ports
Displays the usability status of interfaces configured for IP.
Displays the IP Forwarding table.
Displays a list of all routes (static and dynamic) that exist in the IP
router database.
Displays IP configuration parameters.
Displays switch routing protocol information and status.
Displays the current status of TCP/UDP service ports. Includes service
name and well-known port number.
Displays the ARP table.
This command allows the viewing of the ICMP control settings.
Displays the configuration parameters of the DoS scan for the switch.
Displays the statistics on detected port scans for the switch.
OmniSwitch 6624/6648 Network Configuration Guide
show udp statistics
command to display UDP port information.
Configuring IP
April 2004