Disabling An Ip Address From Receiving Switch Logging Output; Displaying Switch Logging Status - Alcatel OmniSwitch 6624 Network Configuration Manual

Switch Logging Commands Overview

Disabling an IP Address from Receiving Switch Logging Output

To disable a particular IP address from receiving switch logging output, enter the following command:
-> no swlog output socket
No confirmation message will appear on the screen.
Note. It is not necessary to specify the IP address in the no swlog output socket command.

Displaying Switch Logging Status

You can display the current status of switch logging onto your console screen by using the
command. The following information is displayed:
The enable/disable status of switch logging.
•
A list of current output devices configured for switch logging.
•
The switch logging severity level for each application that is not set to the "info" (6) setting.
•
The following is a sample display:
-> show swlog
Switch Logging is:
Log Device(s)
----------------
flash
console
Only Applications not at the level 'info' (6) are shown
Application ID
----------------------------
CHASSIS (64)
->
For this example, switch logging is enabled. Switch logging information is being sent to the switch's flash
memory and to the console. Additionally, the severity level for the chassis application ID has been set to
the "debug3" (or "9") severity level.
page 25-10
- INITIALIZED
- RUNNING
Level
debug3 (9)
OmniSwitch 6624/6648 Network Configuration Guide
Using Switch Logging
show swlog
April 2004