Modifying The Partner Port Administrative Key; Modifying The Partner Port System Id - Alcatel OmniSwitch 6624 Network Configuration Manual

Modifying Dynamic Link Aggregate Group Parameters
Note. Since individual bits with the LACPDU frame are set with the lacp agg partner admin state
command you can set some bits on and restore other bits to default values within the same command. For
example, if you wanted to restore bit 2 (aggregate) to its default settings and set bit 0 (active) on dynamic
aggregate partner port 1 in slot 7 you would enter:
-> lacp agg 7/1 partner admin state active no aggregate

Modifying the Partner Port Administrative Key

By default, the dynamic aggregate partner port's administrative key is 0. The following subsections
describe how to configure a user-specified value and how to restore the value to its default value with the
lacp agg partner admin key
Configuring the Partner Port Administrative Key
You can configure the dynamic aggregate partner port's administrative key to a value ranging from 0 to
65535 by entering lacp agg, the slot number, a slash (/), the port number, partner admin key, and the
user-specified partner port administrative key.
For example, to modify the administrative key of a dynamic aggregate group partner port 1 in slot 6 to
1000 enter:
-> lacp agg 6/1 partner admin key 1000
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to modify the administrative key of a dynamic aggregate group partner port 1
in slot 6 to 1000 and document that the port is a 10 Mbps Ethernet port you would enter:
-> lacp agg ethernet 6/1 partner admin key 1000
Restoring the Partner Port Administrative Key
To remove a user-configured administrative key from a dynamic aggregate group partner port's configura-
tion use the no form of the
a slash (/), the port number, and no partner admin key.
For example, to remove the user-configured administrative key from dynamic aggregate partner port 1 in
slot 6, enter:
-> lacp agg 6/1 no partner admin key

Modifying the Partner Port System ID

By default, the partner port system ID (i.e., the MAC address used as the system ID on dynamic aggregate
partner ports) is 00:00:00:00:00:00. The following subsections describe how to configure a user-specified
value and how to restore the value to its default value with the
command.
page 11-28
command.
lacp agg partner admin key
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
command by entering lacp agg, the slot number,
lacp agg partner admin system id
April 2004