Displaying Dynamic Link Aggregation Configuration And Statistics - Alcatel OmniSwitch 6624 Network Configuration Manual

Displaying Dynamic Link Aggregation Configuration and Statistics

Displaying Dynamic Link Aggregation
Configuration and Statistics
You can use Command Line Interface (CLI) show commands to display the current configuration and
statistics of link aggregation. These commands include the following:
show linkagg
show linkagg port
When you use the show linkagg command without specifying the link aggregation group number and
when you use the show linkagg port command without specifying the slot and port number, these
commands provide a "global" view of switch-wide link aggregate group and link aggregate port informa-
tion, respectively.
For example, to display global statistics on all link aggregate groups (both dynamic and static) you would
enter
-> show linkagg
A screen similar to the following would be displayed:
Number Aggregate
-------+----------+--------+----+-------------+-------------+-------------
1 Static
2 Dynamic
3 Dynamic
4 Static
When you use the show linkagg command with the link aggregation group number and when you use the
show linkagg port command with the slot and port number, these commands provide detailed views of
link aggregate group and port information, respectively. These detailed views provide excellent tools for
diagnosing and troubleshooting problems.
For example, to display detailed statistics for port 1 in slot 2 that is attached to dynamic link aggregate
group 1 you would enter:
-> show linkagg port 2/1
page 11-36
Displays information on link aggregation groups.
Displays information on link aggregation ports.
SNMP Id Size Admin State
40000001 8 ENABLED
40000002 4 ENABLED
40000003 8 ENABLED
40000005 2 DISABLED
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Dynamic Link Aggregation
Oper State Att/Sel Ports
UP 2 2
DOWN 0 0
DOWN 0 2
DOWN 0 0
April 2004