Setting Ethernet Port Parameters
Setting Ethernet Port Parameters
When using CLI commands to set Ethernet port parameters, keep in mind that Ethernet and Fast Ethernet
are supported only on ports 1 through 48 on the OmniSwitch 6648 and ports 1 through 24 on the
OmniSwitch 6624. Likewise, Gigabit Ethernet is only supported on OmniSwitch 6648 ports 49 through 52
and OmniSwitch 6624 and 6600-U24 ports 25 through 28 when the optional Gigabit expansion modules
are installed.
Setting Trap Port Link Messages
The
trap port link
command can be used to enable or disable (the default) trap port link messages on a
specific port, a range of ports, or all ports on a switch (slot). When enabled, a trap message will be
displayed on a Network Management Station (NMS) whenever the port state has changed.
Enabling Trap Port Link Messages
To enable trap port link messages on an entire switch, enter trap followed by the slot number and port
link enable. For example, to enable trap port link messages on all ports on slot 2 enter:
-> trap 2 port link enable
To enable trap port link messages on a single port enter trap followed by the slot number, a slash (/), the
port number, and port link enable. For example, to enable trap port link messages on slot 2 port 3 enter:
-> trap 2/3 port link enable
To enable trap port link messages on a range of ports port enter trap followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, and port link enable. For example, to
enable trap port link messages ports 3 through 5 on slot 2 enter:
-> trap 2/3-5 port link enable
Disabling Trap Port Link Messages
To disable trap port link messages on an entire switch, enter trap followed by the slot number and port
link disable. For example, to disable trap port link messages on all ports on slot 2 enter:
-> trap 2 port link disable
To disable trap port link messages on a single port enter trap followed by the slot number, a slash (/), the
port number, and port link disable. For example, to disable trap port link messages on slot 2 port 3 enter:
-> trap 2/3 port link disable
To disable trap port link messages on a range of ports port enter trap followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, and port link disable. For example, to
disable trap port link messages ports 3 through 5 on slot 2 enter:
-> trap 2/3-5 port link disable
page 1-8
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Ethernet Ports
April 2004