Sample Vlan Configuration - Alcatel OmniSwitch 6624 Network Configuration Manual

Configuring VLANs

Sample VLAN Configuration

The following steps provide a quick tutorial that will create VLAN 255 on a stack configuration that
includes four OmniSwitch 6648 units. Also included are steps to define a VLAN description, IP router
port, and static switch port assignments.
Note. Optional. Creating a new VLAN involves specifying a VLAN ID that is not already assigned to an
existing VLAN. To determine if a VLAN already exists in the switch configuration, enter show vlan. If
VLAN 255 does not appear in the show vlan output, then it does not exist on the switch. For example,
-> show vlan
vlan admin
+------+------+------+-------+-----+----+----+------+----------+
1 on
30 on
400 on
1
Create VLAN 255 with a description (e.g., Finance IP Network) using the following command:
-> vlan 255 name "Finance IP Network"
2 Define an IP router port using the following command to assign an IP host address of 21.0.0.10 to
VLAN 255 that will enable routing of VLAN traffic to other subnets:
-> vlan 255 router ip 21.0.0.10
3
Assign switch ports 2 through 4 on switch 3 in the stack to VLAN 255 using the following command:
-> vlan 255 port default 3/2-4
Note. Optional. To verify the VLAN 255 configuration, use the
-> show vlan 255
Name
Administrative State: enabled,
Operational State
Spanning Tree State : enabled,
Authentication
IP Router Port
IPX Router Port
Mobile Tag
To verify that ports 3/2-4 were assigned to VLAN 255, use the
-> show vlan 255 port
port type
--------+---------+--------------
3/2 default
3/3 default
3/4 default
OmniSwitch 6624/6648 Network Configuration Guide
oper stree auth
off on off
off on off
off on off
: Finance IP Network,
: disabled,
: disabled,
: 21.0.0.10 255.0.0.0
: NA
: off
status
inactive
inactive
inactive
mble
ip ipx tag name
off NA off VLAN 1
off NA on VLAN 30
off NA on VLAN 400
show vlan
forward e2,
show vlan port
April 2004
Sample VLAN Configuration
command. For example:
command. For example:
page 4-3