Defining Dhcp Generic Rules; Defining Binding Rules - Alcatel OmniSwitch 6624 Network Configuration Manual

Hide thumbs Also See for OmniSwitch 6624:
Table of Contents

Advertisement

Configuring VLAN Rule Definitions

Defining DHCP Generic Rules

DHCP generic rules capture all DHCP traffic that does not match an existing DHCP MAC or DHCP port
rule. If none of these other rules exist, then all DHCP frames are captured regardless of the port they came
in on or the frame's source MAC address. Only one rule of this type is allowed per switch.
To define a DHCP generic rule, enter vlan followed by an existing VLAN ID then dhcp generic. For
example,
-> vlan 255 dhcp generic
Use the no form of the
-> vlan 255 no dhcp generic

Defining Binding Rules

Binding rules require mobile port traffic to match all rule criteria. The criteria consists of one of six combi-
nations, each of which is a specific binding rule type:
1
The device must attach to a specific switch port and use a specific MAC address and use a specific IP
network address (MAC-port-IP address binding rule).
2
The device must attach to a specific switch port and use a specific source MAC address and use a
specific protocol (MAC-port-Protocol binding rule).
3
The device must use a specific port and a specific source MAC address (MAC-port binding rule).
4
The device must use a specific IP address and use a specific MAC address (MAC-IP address binding
rule).
5
The device must use a specific port and a specific IP address (port-IP address binding rule).
6
The device must attach to a specific switch port and use a specific protocol (port-protocol binding
rule).
If frames do not contain matching criteria, they are compared against other existing VLAN rules of lower
precedence. However, if a frame violates criteria of any one binding rule, it is discarded. Refer to
standing VLAN Rule Precedence" on page 7-8
Note that MAC-port-IP, MAC-port-Protocol, MAC-port, and port-IP binding rules are also supported on
Authenticated VLANs (AVLANs). See
mation.
The following subsections provide information about how to define each of the binding rule types.
page 7-14
vlan dhcp generic
command to remove a DHCP generic rule.
for more information.
Chapter 18, "Configuring Authenticated VLANs,"
OmniSwitch 6624/6648 Network Configuration Guide
Defining VLAN Rules
"Under-
for more infor-
April 2004

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 6648

Table of Contents