Configuring Static Link Aggregation
Modifying Static Aggregation Group Parameters
This section describes how to modify the following static aggregate group parameters:
Static aggregate group name (see
•
Static aggregate group administrative state (see
•
tive State" on page
Modifying the Static Aggregate Group Name
The following subsections describe how to modify the name of the static aggregate group with the
linkagg name
command.
Creating a Static Aggregate Group Name
To create a name for a static aggregate group by entering static linkagg followed by the number of the
static aggregate group, name, and the user-specified name of the group, which can be up to 255 charac-
ters long. For example, to configure static aggregate group 4 with the name "Finance" you would enter:
-> static linkagg 4 name Finance
Note. If you want to specify spaces within a name for a static aggregate group the name must be specified
within quotes (e.g., "Static Aggregate Group 4").
Deleting a Static Aggregate Group Name
To remove a name from a static aggregate group you use the no form of the
command by entering static linkagg followed by the number of the static aggregate group and no name.
For example, to remove any user-specified name from static aggregate group 4 you would enter:
-> static linkagg 4 no name
Modifying the Static Aggregate Group Administrative State
By default, the administrative state for a static aggregate group is enabled. The following subsections
describe how to enable and disable the administrative state with the
Enabling the Static Aggregate Group Administrative State
To enable a static aggregate group by entering static linkagg followed by the number of the group and
admin state enable. For example, to enable static aggregate group 1 you would enter:
-> static linkagg 1 admin state enable
Disabling the Static Aggregate Group Administrative State
To disable a static aggregate group by entering static linkagg followed by the number of the group and
admin state disable. For example, to disable static aggregate group 1 you would enter:
-> static linkagg 1 admin state disable
OmniSwitch 6624/6648 Network Configuration Guide
"Modifying the Static Aggregate Group Name" on page
10-13)
Modifying Static Aggregation Group Parameters
"Modifying the Static Aggregate Group Administra-
static linkagg admin state
April 2004
10-13)
static
static linkagg name
command.
page 10-13