Loading Rip; Enabling Rip - Alcatel OmniSwitch 6624 Network Configuration Manual

Hide thumbs Also See for OmniSwitch 6624:

Table of Contents

OmniSwitch 6648

Loading RIP

When the switch is initially configured, RIP must be loaded into switch memory. Use the

command to load RIP.

To remove RIP from switch memory, you must manually edit the boot.cfg file. The boot.cfg file is an

ASCII text-based file that controls many of the switch parameters. Open the file and delete all references

to RIP. You must reboot the switch when this is complete.

Note. In simple networks where only IP forwarding is required, you may not want to use RIP. If you are

not using RIP, it is best not to load it to save switch resources.

RIP is disabled by default. Use the

-> ip rip status enable

Use the ip rip status disable command to disable RIP routing on the switch. Use the

command to display the current RIP status.

ip rip status

OmniSwitch 6624/6648 Network Configuration Guide

Router Port/

RIP Interface

command to enable RIP routing on the switch. For exam-

Configuring RIP

OmniSwitch 6648

Omniswitch 6648