RDP Specifications
RDP Specifications
RFCs Supported
Router advertisements
Host solicitations
Maximum number of RDP interfaces per
switch
Advertisement destination addresses
RDP Defaults
Parameter Description
RDP status for the switch
RDP status for switch interfaces
(router VLAN IP addresses)
Advertisement destination address
for an active RDP interface.
Maximum time between advertise-
ments sent from an active RDP inter-
face
Minimum time between advertise-
ments sent from an active RDP inter-
face
Maximum time IP addresses con-
tained in an advertisement packet are
considered valid
Preference level for IP addresses
contained in an advertisement packet
page 14-2
RFC 1256–ICMP Router Discovery Messages
Supported
Only responses to solicitations supported in this
release.
One for each available IP interface configured
on the switch.
224.0.0.1 (all systems multicast)
255.255.255.255 (broadcast)
CLI Command
ip router-discovery
ip router-discovery
interface
ip router-discovery
interface advertise-
ment-address
ip router-discovery
interface max-adver-
tisement-interval
ip router-discovery
interface min-adver-
tisement-interval
ip router-discovery
interface advertise-
ment-lifetime
ip router-discovery
interface preference-
level
OmniSwitch 6624/6648 Network Configuration Guide
Default Value/Comments
Disabled
Disabled
All systems multicast (224.0.0.1)
600 seconds
450 seconds
(0.75 * maximum advertisement interval)
1800 seconds
(3 * maximum advertisement interval)
0
Configuring RDP
April 2004