Alcatel OmniSwitch 6624 Network Configuration Manual page 221

Configuring Dynamic Link Aggregation
For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to 100 you would
enter:
-> lacp agg 4/3 partner admin port priority 100
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation Alca-
tel CLI syntax. For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to
100 and document that the port is a Fast Ethernet port you would enter:
-> lacp agg fastethernet 4/3 partner admin port priority 100
Restoring the Partner Port Priority
To remove a user-configured partner port priority from a dynamic aggregate group partner port's configu-
ration use the no form of the
slot number, a slash (/), the port number, and no partner admin port priority.
For example, to remove a user-configured partner port priority from dynamic aggregate partner port 3 in
slot 4 you would enter:
-> lacp agg 4/3 no partner admin port priority
OmniSwitch 6624/6648 Network Configuration Guide
lacp agg partner admin port priority
April 2004
Modifying Dynamic Link Aggregate Group Parameters
command by entering lacp agg, the
page 11-31