Enabling And Disabling Flow - Alcatel OmniSwitch 6624 Network Configuration Manual

Setting Ethernet Port Parameters
To configure crossover settings on a single port enter interfaces followed by the slot number, a slash (/),
the port number, crossover, and the desired setting. For
example, to set the crossover configuration to auto on port 3 on slot 2 enter:
-> interfaces 2/3 crossover auto
To configure crossover settings on a range of ports enter interfaces followed by the slot number, a slash
(/), the first port number, a hyphen (-), the last port number, crossover, and the desired setting.
For example, to set the crossover configuration to auto on ports 1 through 3 on slot 2 enter:
-> interfaces 2/1-3 crossover auto
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to set the crossover configuration to auto on port 3 on slot 2 and
document the port as Fast Ethernet enter:
-> interfaces fastethernet 2/3 crossover auto

Enabling and Disabling Flow

By default, flow (pause) is enabled. To enable or disable flow control on a single port, a range of ports, or
an entire NI use the interfaces flow
control will also be disabled.
To enable or disable flow control on an entire switch enter interfaces followed by the slot number, flow,
and either enable or disable. For example, to enable flow control on slot 2 enter:
-> interfaces 2 flow enable
To enable or disable flow control on a single port enter interfaces followed by the slot number, a
slash (/), the port number, flow, and either enable or disable. For example, to enable flow control on port
3 on slot 2 enter:
-> interfaces 2/3 flow enable
To enable or disable flow control on a range of ports enter interfaces followed by the slot number, a slash
(/), the first port number, a hyphen (-), the last port number, flow, and either enable or disable. For exam-
ple, to enable flow control on ports 1 through 3 on slot 2 enter:
-> interfaces 2/1-3 flow enable
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to enable flow control on port 3 on slot 2 and document the port as
Fast Ethernet enter:
-> interfaces fastethernet 2/3 flow enable
Note. If auto negotiation is disabled and then later enabled on an interface, the original flow setting will
then be restored.
page 1-18
command. Please note that if auto negotiation is disabled then flow
OmniSwitch 6624/6648 Network Configuration Guide
Configuring Ethernet Ports
April 2004