Show Igmp Access_Authentication Ports - D-Link DGS-1100-06/ME Cli Reference Manual

Parameters
Restrictions
Example usage:
To configure authentication port of IGMP:
DGS-1100-06/ME:5#config igmp access_authentication ports all state
enable
Command: config igmp access_authentication ports all state enable
Success !
DGS-1100-06/ME:5#

show igmp access_authentication ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the IGMP access authentication:
DGS-1100-06/ME:5#show igmp access_authentication ports all
Command: show igmp access_authentication ports all
Port Authentication State
------ ----------------------------
1
2
3
4
5
6
DGS-1100-06/ME:5#
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
configures the IGMP access authentication on the Switch.
<portlist> − A port or range of ports that will be configured as IGMP
access authentication ports.
all − Specify all ports to be configured as IGMP access
authentication ports.
state[enable | disable] − Specifies the state for the port to be
disabled or enabled.
Only administrator or operator-level users can issue this command.
To display the IGMP access authentication configuration on the
Switch.
show igmp access_authentication ports [<portlist> | all]
The show igmp access_authentication command displays the
IGMP access authentication configuration on the Switch.
all − Specifies all ports to be displayed.
<portlist> − A port or range of ports to be displayed on the Switch.
None.
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
148