Rep 9.10 Developer - Xerox DocuColor 1632 Service Manual

REP 9.10 Developer

Parts List on PL 6.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Front Cover (REP 14.7).
2. Remove Drum Cartridges.
3. Remove Waste Cartridge (REP 9.4).
4. Remove Waste Cartridge Cover (REP
5. Remove Fuser Front Cover (REP 14.8).
6. Release and move Xerographic Release Lever half way down.
7. Remove Dispenser Assembly Cover
8. Remove all Dispenser Assemblies
NOTE: In next step, do not remove sensor.
9. Remove housing for Waste Cartridge Full Sensor
NOTE: In next step, it may not be necessary to disconnect harnesses for Plate Assembly (PL
4.2) to remove a developer housing.
10. Remove Plate Assembly (REP 9.8).
11. Remove Developer Housing (REP
12. Remove Developer. (Figure 1).
a. Carefully observe position of wiring harness for later reinstallation.
Figure 1 Observing position of Harness
b. Remove Housing Cover (Figure
Repairs and Adjustments
REP 9.10
WARNING
9.3).
(REP 9.6).
(REP 9.7).
(REP 9.5).
9.9).
Position of
Harness
2).
2
Release tabs and
remove Cover
Figure 2 Removing Housing Cover
c. Rotate Drive Gear to remove Developer
Figure 3 Removing Developer
Replacement
1. Rotate Drive Gear while installing new Developer
6/02
4-76
1
Place Drop Cloth
(Figure 3).
Drive Gear
(Figure 4).
Prelaunch Training/Review
DC1632/2240