REP 9.5 Full Toner Sensor
Parts List on
PL 4.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Open Front Cover.
2.
Remove Waste Cartridge
(REP
9.4).
3.
Remove Waste Cartridge Cover
(REP
4.
Access Waste Cartridge Full Sensor
a.
Lift Left End slightly and pull left to disengage Mounting Tabs.
b.
Rotate Sensor Support and remove. Left End harness connection limits movement.
Connected
Harness
Left
End
Figure 1 Accessing Waste Cartridge Full Sensor
5.
Remove Waste Cartridge Full Sensor
a.
Push against Sensor Head while releasing Locking Tabs.
b.
Disconnect sensor from harness.
Locking
Tabs
Sensor
Head
Figure 2 Removing Waste Cartridge Full Sensor
Prelaunch Training/Review
DC1632/2240
WARNING
9.3).
(Figure
1).
Sensor
Mounting Tabs
Support
(Figure
2).
Waste Car-
tridge Full
Sensor
REP 9.6 Inner Cover
Parts List on
PL 10.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Open Front Cover.
2.
Open Left Cover Assembly.
3.
Remove Y, M, C, K, Drum.
4.
Remove Fuser Front Cover
(REP
5.
Release and move Xerographic Release Lever half way down.
6.
Remove Dispenser Assembly Cover
a.
Remove Screws (4).
b.
Remove Dispenser Assembly Cover.
Screws (4)
Figure 1 Removing Toner Transport Cover
6/02
4-71
WARNING
14.8).
(Figure
1).
Repairs and Adjustments
REP 9.5, REP 9.6