Rep 6.11 Carriage Cables - Xerox DocuColor 1632 Service Manual

REP 6.11 Carriage Cables

Parts List on PL 18.5
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
NOTE: This page describes how to remove Rear Carriage Cable.
NOTE: Do not replace both cables at same time. Remove front and rear cables separately.
1. Remove DADF (REP 5.1).
2. Remove Platen Glass (REP 6.1).
3. Remove IIT Top Cover (REP 6.3).
4. DADF machines: Remove registration gate and plate
a. 1. Remove screws (2).
b. 2. Remove Registration Gate.
c. 3. Remove screws (2).
d. 4. Remove plate.
Figure 1 Removing Registration Gate and Plate
5. Remove Full Rate Carriage from IIT Frame
tor connected.
Repairs and Adjustments
REP 6.11
WARNING
(Figure 1).
(REP 6.14). Keep lamp wire harness connec-
6. Move Half Rate Carriage so that position of Carriage Cable Ball on Capstan is one of fol-
lowing: (Figure 2).
ï Two Carriage Cable Rolls in front and rear.
ï Carriage Cable Ball is directly above.
Figure 2 Positioning Half Rate Carriage
6/02
4-44
Prelaunch Training/Review
DC1632/2240