REP 56.10.1 DADF Takeaway Roll
Parts List on
PL 56.10
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1.
Remove the DADF Front Cover.
(REP
2.
Remove the DADF Rear Cover.
(REP
3.
Remove the Document Tray.
(REP
4.
Remove the Harness Guide and the wire harness.
5.
Remove the Upper Feeder.
(REP
56.2.4)
6.
Remove the Invert Chute.
(REP
56.9.3)
7.
Remove the DADF Feed Motor.
(REP
8.
Remove the link. (Figure 1)
(1) Remove the link.
Figure 1 j0lj45631
9.
Remove the gear and bracket. (Figure 2)
(1) Remove the washer (large: thin).
(2) Remove the washer (small: thick).
(3) Remove the gear and bracket.
Repairs and Adjustments
REP 56.10.1
WARNING
56.2.1)
56.2.2)
56.9.1)
(REP
56.6.1)
56.6.2)
10. Remove the DADF Takeaway Clutch. (Figure 3)
(1) Remove the E-Clip.
(2) Remove the DADF Takeaway Clutch.
11. Remove the gear. (Figure 4)
(1) Loosen the screw.
(2) Remove the spring.
(3) Remove the gear.
08/2012
4-80
Figure 2 j0lj45632
Figure 3 j0lj45633
WorkCentre 5021/5019
Initial Issue