Rep 8.2 Duplex Chute - Xerox DocuColor 1632 Service Manual

REP 8.2 Duplex Chute

Parts List on PL 2.8
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Rear Cover (REP 14.2).
2. Remove Power Switch Cover (REP
3. Remove Upper Rear Left Cover (REP
4. Close Left Cover Assembly.
5. Remove Tray 5 (REP 7.1).
6. Open and close Left Cover Assembly to allow Duplex Paper Guide to swing down.
7. Swing Duplex Paper Guide back and forth while carefully pushing Duplex Paper Guide
toward rear. Key in front hinge pin will enter hinge pin slot and front hinge pin will disen-
gage hinge pin hole. Move Duplex Paper Guide toward front to disengage rear hinge pin.
Replacement
Install Left Cover Assembly on hinge pins, manually align marks on Motion Damper, then tip
up transport to engage Motion Damper gears and connect stop arm on Stop Pin
Prelaunch Training/Review
DC1632/2240
WARNING
14.6).
14.4).
Before closing Left Cover Assembly to connect harness, hold up black plastic Duplex Baffle
while closing transport.
(Figure 3).
6/02
4-65
CAUTION
Marks on
Stop Pin
Motion
Damper
Figure 1 Aligning Marks on Motion Damper
Hinge
Pin
Repairs and Adjustments
REP 8.2