Rep 9.21 Left Lift Assembly - Xerox DocuColor 1632 Service Manual

REP 9.21 Left Lift Assembly

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open Front Cover.
2. Remove Fuser Front Cover (REP 14.8).
3. Remove Waste Cartridge (REP 9.4).
4. Remove Waste Cartridge Cover (REP
5. Remove Inner Left Harness Cover
6. Release and move Xerographic Release Lever down.
7. Remove Drum Cartridges.
8. Remove Right Cover (REP 14.3).
9. Remove Belt Module (REP 9.15).
10. Remove Xerographic Release Lever
11. Remove Rear Cover (REP 14.2).
12. Remove Power Switch Cover (REP
13. Remove Upper Rear Left Cover (REP
14. Close Left Cover Assembly.
15. Remove MSI Tray (REP 7.1).
16. Remove Left Cover Assembly (REP
17. Optional for improved visibility: Remove Fuser Module
18. Remove Registration Transport (REP
19. Remove Dispenser Assembly Cover
20. Remove Waste Toner Agitator (REP
21. Remove Belt Mark Sensor (REP 9.14).
22. Remove Left Xerographic Release Lever Bracket
23. Remove Front Cover (REP 14.7).
24. Remove K and C Toner Cartridges.
25. Remove K and C Dispenser Assembly
NOTE: In next step, do not remove sensor from housing
26. Remove housing for Waste Cartridge Full Sensor
NOTE: In next step, it may not be necessary to disconnect harnesses for Plate Assembly (PL
4.2) to remove a developer housing.
27. Remove Plate Assembly (REP 9.8).
28. Remove K and C Developer Housing
29. Remove Left Xerographic Lift (Figure
NOTE: In next step, use a magnet to capture E-Ring and Washer while removing them.
a. From inside Developer Housing cavity, remove E-Ring and Washer from each end of
Left Xerographic Lift.
Prelaunch Training/Review
DC1632/2240
WARNING
9.3).
(REP 14.10).
(REP 9.18).
14.6).
14.4).
8.1).
(REP 10.1).
8.6).
(REP 9.6).
9.13).
(REP 9.19).
(REP 9.7).
(REP 9.5).
(REP 9.9).
1).
b. Remove Screws (4).
c. Remove Left Xerographic Lift and maintain orientation to ensure Bearings (2) and
Washers (2) do not fall off posts.
Screws (2)
Washer
Screws (2)
Figure 1 Removing Left Xerographic Lift
Replacement
1. Install Lift.
a. Position Lift in frame.
b. Raise or lower xerographic frame as required and push in or pull out Lift actuator as
required to engage lift bearings with slots in xerographic frame.
c. Install front top screw, then front bottom screw, then rear screws (2).
d. Install washers (2) and e-rings (2).
2. Assemble remaining machine components.
6/02
4-83
Bearing Washer
E-Ring
E-Ring
Repairs and Adjustments
REP 9.21