Xerox DocuColor 1632 Service Manual page 69

3-947 Tray 2 Not In Position
Tray 2 not in ready position.
Initial Actions
ï Check that the paper size setting is correct.
ï Check the Paper Size Sensor for obstructions or damage.
Procedure
Ensure Tray 2 is closed. The voltage measured at P/J546-8 on the Tray Module PWB (PL
16.15) corresponds to the paper size in the table.
Y N
There is +5VDC measured at P/J546-9 on the Tray Module PWB (PL 16.15)
Y N
Check the wires and connectors. If the check is OK, replace the Tray Module PWB
(PL 16.15)
Check the wires and connectors. If the check is OK, replace the Tray 2 Paper Size Sensor
(PL 16.1).
Check the wires and connectors, If the check is OK, replace the Tray Module PWB (PL 16.15).
If the problem continues, replace the Tray 2 Paper Size Sensor (PL 16.1).
Figure 1 Tray 2 Paper Size Sensor
Prelaunch Training/Review
DC1632/2240
3-948 Tray 3 Not In Position
Tray 3 not in ready position.
Initial Actions
ï Check that the paper size setting is correct.
ï Check the Paper Size Sensor for obstructions or damage.
Procedure
Ensure Tray 3 is closed. The voltage measured at P/J548-11 on the Tray Module PWB (PL
16.15) corresponds to the paper size in the table.
Y N
There is +5VDC measured at P/J548-12 on the Tray Module PWB (PL 16.15)
Y N
Check the wires and connectors. If the check is OK, replace the Tray Module PWB
(PL 16.15)
Check the wires and connectors. If the check is OK, replace the Tray 3 Paper Size Sensor
(PL 16.1).
Check the wires and connectors, If the check is OK, replace the Tray Module PWB (PL 16.15).
If the problem continues, replace the Tray 3 Paper Size Sensor (PL 16.1).
Figure 1 Tray 3 Paper Size Sensor
6/02
2-39
Status Indicator RAPs
3-947, 3-948