Rep 10.1 Fuser Assembly - Xerox WorkCentre 4150 Service Manual

REP 10.1 Fuser Assembly

Parts List on PL 10.10, PL 10.25 and PL 10.26
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Do not touch the fuser while it is hot.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Open the side cover assembly, PL 7.30 Item 1.
2. Remove the fuser assembly, Figure 1.
Figure 1 Fuser assembly removal
WorkCentre 4150
2
Remove the fuser
assembly.
1
Remove 4 screws.
September 2006
Replacement
Do not damage the exit sensor actuator when reinstalling the fuser assembly. Refer to Figure
2.
1. Replacement is the reverse of the removal procedure.
2. Ensure the exit sensor actuator is pushed to the left when the fuser assembly is rein-
stalled, Figure 2.
Figure 2 Fuser assembly replacement
3. If a new fuser assembly is installed, reset the HFSI count. Go to GP 16 High Frequency
Service Items.
4-43
CAUTION
1
Push the exit sensor actuator to the left.
Repairs and Adjustments
REP 10.1