Toner Cartridge (K) Near Empty; Change Drum Cartridge (K) Soon - Xerox DocuColor 1632 Service Manual

9-413 Toner Cartridge (K) Near Empty

The Black Toner Cartridge is nearly empty.
NOTE: Continuous running of high density prints can temporally deplete the toner supply.
Initial Actions
ï Ensure that there is toner and the toner is evenly distributed in the cartridge (K).
ï Check the ATC Sensor (K) for blockage or contaminants.
ï Check the drive system from the Main Drive Motor to the Developer Housing (K) for dam-
age.
Procedure
Enter dC330 [009-004]. The Toner Dispense Motor (K) energizes (PL 6.1).
Y N
Go to OF 99-6 Motor Open RAP.
Enter dC330. Stack the codes [004-004, Main Motor] and [009-013, Dev. Clutch (K)]. The
Black Developer Assy. energizes (PL 1.1).
Y N
Go to OF 99-6 Motor Open RAP (refer to BSD 4.1 and BSD 9.13 for circuit).
Check ADJ 9.3. The ATC Sensor (K) fail judgement is OK.
Y N
Go the 9-383, ATC Sensor Failure (K) RAP.
After checking that no failures are detected during normal operation, go to call closeout.
Figure 1 Toner Dispense Motor K
Prelaunch Training/Review
DC1632/2240

9-428 Change Drum Cartridge (K) Soon

The Drum Cartridge (K) needs to be replaced soon/reached end of life.
Procedure
Replace the Black Drum Cartridge (refer to Section 6,
is corrected.
Y N
Replace the MCU PWB (PL 13.1).
Return to Service Call Procedures.
6/02
2-153
Machine Consumables). The problem
Status Indicator RAPs
9-413, 9-428