REP 9.10 Developer
Parts List on
PL 6.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Remove Front Cover
(REP
14.7).
2.
Remove Drum Cartridges
(REP
9.1).
3.
Remove Waste Toner Cartridge
(REP
4.
Remove Waste Cartridge Toner Cover
5.
Remove Fuser Cover
(REP
14.8).
6.
Remove Dispenser Cover
(REP
9.6).
7.
Remove all Toner Dispensers
(REP
NOTE: In next step, do not remove sensor.
8.
Remove housing for Full Toner Sensor
NOTE: In next step, it may not be necessary to disconnect harnesses for Plate Assembly (PL
4.2) to remove a developer housing.
9.
Remove Plate Assembly
(REP
9.8).
10. Remove Developer Housing
(REP
11. Remove Developer.
(Figure
1).
a.
Carefully observe position of wiring harness for later reinstallation.
Figure 1 Observing position of Harness
b.
Remove Housing Cover
(Figure
Repairs and Adjustments
REP 9.10
WARNING
9.4).
(REP
9.3).
9.7).
(REP
9.5).
9.9).
Position of
Harness
2).
2
Release tabs and
remove Cover
Figure 2 Removing Housing Cover
c.
Rotate Drive Gear to remove Developer
Figure 3 Removing Developer
Replacement
1.
Rotate Drive Gear while installing new Developer
02/03
4-80
1
Place Drop Cloth
(Figure
3).
Drive Gear
(Figure
4).
Initial issue
DC 3535/2240/1632