Brocade Communications Systems Brocade 8/12c Command Reference Manual page 635

iproute
Fabric OS Command Reference
53-1001764-01
Valid options and arguments for ipif include the following:
create src_ipaddr [netmask] mtu_size
Creates IP interfaces. Specify the following:
src_ipaddr
Specifies source IP address in either IPv6 or IPv4 format:
src_IPv6_addr/prefix_len
Specifies the source IPv6 address of the virtual port if IPv6 is used. The
address must be an IPv6 global, unicast address, followed by a prefix. This is
used for IPv6 addresses instead of a netmask. The prefix_len operator is
required. Refer to the Fibre Channel over IP Administrator's Guide for more
information on IPv6 rules and restrictions.
src_IPv4_addr netmask
Specifies the source IPv4 address of the virtual port, if IPv4 is used. If an IPv4
address is used, the subnet mask must be specified as well (in a.b.c.d.
format.)
mtu_sizemtu_size
Specifies the maximum transmission unit size. The permitted range is 1260
Bytes to 1500 Bytes for the Brocade 7800/FX8-24 platforms and 1260 Bytes
to 2348 Bytes for the Brocade FR4-18i. This operand is required.
-x | --crossport
Configures an interface for a failover crossport. A crossport is defined as the
nonlocal (secondary) XGE port to a VE_Port group that provides failover
capabilities for the tunnel configured on the local XGE port. For VE_Ports
12-21, xge1 is the local XGE port and xge0 is the crossport. For VE_Ports
22-31, xge0 is the local XGE port and xge1 is the crossport. This operand is
optional and supported only on the Brocade FX8-24 XGE ports.
delete ipaddr
Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port.
Defines static IP routes on a GbE port or on a 10GbE port. After defining the IP
interface on the remote switch, you can define destination routes for an interface.
A maximum of 32 user-configurable routes per GbE/10GbE port are supported.
You cannot use this command to configure routes for inband management; use
portCfg mgmtroute instead. In Fabric OS v7.0.0, you can use this command to
configure an iproute for a XGE port configured as a failover crossport. This feature
is supported only on the FX8-24.
The syntax for portcfg iproute is as follows:
portcfg iproute [slot/]ge_port option args [optional_args]
Valid options and arguments for iproute include the following:
create dest_ipaddr [netmask] [gateway_router] metric
Creates an IP route. Specify the following:
dest_ipaddr
Specifies the destination IP address in either IPv6 or IPv4 format:
dest_IPv6_addr/prefix_len
Specifies the destination IPv6 address of the virtual port, if IPv6 is used. The
address must be an IPv6 global, unicast address, followed by a prefix. This is
used for IPv6 addresses instead of a netmask. The prefix_len operand is
required.
22
portCfg
601