Trackchangesset - Brocade Communications Systems Brocade 8/12c Command Reference Manual

trackChangesSet

Configures the track-changes feature.
SYNOPSIS
trackchangesset [mode][,snmptrapmode]
DESCRIPTION
Use this command to enable or disable the track-changes feature and to configure the SNMP-TRAP
mode. When enabled, this command tracks the following changes:
•
•
•
•
The output from the track-changes feature is dumped to the switch error log. Use errDump or errShow
to view the error log.
When used without operand, this command displays the usage.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
mode
snmptrapmode
EXAMPLES
To enable the track-changes feature:
To display the configuration:
SEE ALSO
trackChangesHelp,
Fabric OS Command Reference
53-1001764-01
Successful login
Unsuccessful login
Logout
Enabling or disabling of the track-changes feature
Specify 1 to enable the track-changes feature or specify 0 to disable the feature.
Track-changes is disabled by default.
Specify 1 to enable sending messages to the SNMP-TRAP in addition to the error
log. Specify 0 to disable the SNMP-TRAP messages. The SNMP-TRAP mode is
disabled by default. This operand is optional; if omitted, this command disables
the SNMP-TRAP mode.
switch:admin> trackchangesset 1,1
Committing configuration...done.
switch:admin> trackchangesshow
Track changes status: ON
Track changes generate SNMP-TRAP: YES
trackChangesShow
22
trackChangesSet
1025