Displaying Information About An Upstream Neighbor Device - Dell PowerConnect B-RX Configuration Manual

23
Displaying PIM Sparse configuration information and statistics
BigIron RX(config-pim-router)# show ip pim nbr
Port
e3/8
Port
v1
Syntax: show ip pim nbr
This display shows the following information.
This field...
Port
Neighbor
Holdtime sec
Age sec
UpTime sec

Displaying information about an upstream neighbor device

You can view information about the upstream neighbor device for a given source IP address for IP
PIM and DVMRP packets. For PIM, the software uses the IP route table or multicast route table to
lookup the upstream neighbor device. For DVMRP, the software uses the DVMRP route table to
locate the upstream neighbor device.
Enter the following command at the Privileged EXEC level of the CLI.
BigIron RX# show ip pim rpf 1.1.20.2
directly connected or via an L2 neighbor
NOTE
If there are multiple equal cost paths to the source, the show ip pim rpf command output may not
be accurate. If your system has multiple equal cost paths, use the command show ip pim mcache
to view information about the upstream neighbor.
The following example outputs show other messages that the BigIron RX displays with this
command.
622
Neighbor Holdtime
sec
207.95.8.10 180
Neighbor Holdtime
sec
207.95.6.2 180
Age UpTime
sec sec
60 900
Age UpTime
sec sec
60 900
Displays...
The interface through which the BigIron RX is connected to the neighbor.
The IP interface of the PIM neighbor interface.
Indicates how many seconds the neighbor wants this BigIron RX to hold
the entry for this neighbor in memory. The neighbor sends the Hold Time
in its Hello packets.
•
If the BigIron RX receives a new Hello packet before the Hold Time
received in the previous packet expires, the BigIron RX updates its
table entry for the neighbor.
•
If the BigIron RX does not receive a new Hello packet from the
neighbor before the Hold time expires, the BigIron RX assumes the
neighbor is no longer available and removes the entry for the
neighbor.
The number of seconds since the BigIron RX received the last hello
message from the neighbor.
The number of seconds the PIM neighbor has been up. This timer starts
when the BigIron RX receives the first Hello messages from the neighbor.
BigIron RX Series Configuration Guide
53-1002253-01