Displaying Ipv6 Tcp Information - Dell PowerConnect B-RX Configuration Manual

TABLE 180
This field...
Router <ipv6 address> on <interface>
<port>
Last update
Hops
Lifetime
Reachable time
Retransmit time

Displaying IPv6 TCP information

You can display the following IPv6 TCP information:
•
•
To display general information about each TCP connection on the router, enter the following
command at any CLI level.
BigIron RX# show ipv6 tcp connections
Local IP address:port <-> Remote IP address:port TCP state
192.168.182.110:23 <->
192.168.182.110:8218 <->
192.168.182.110:8039 <->
192.168.182.110:8159 <->
2000:4::110:179 <->
Total 5 TCP connections
TCP MEMORY USAGE PERCENTAGE
FREE TCB = 98 percent
FREE TCP QUEUE BUFFER = 99 percent
FREE TCP SEND BUFFER = 97 percent
FREE TCP RECEIVE BUFFER = 100 percent
FREE TCP OUT OF SEQUENCE BUFFER = 100 percent
Syntax: show ipv6 tcp connections
This display shows the following information.
BigIron RX Series Configuration Guide
53-1002253-01
IPv6 local router information fields
General information about each TCP connection on the router, including the percentage of free
memory for each of the internal TCP buffers.
Detailed information about a specified TCP connection.
Displaying global IPv6 information
Displays...
The IPv6 address for a particular router interface.
The amount of elapsed time (in minutes) between the current and
previous updates received from a router.
The default value that should be included in the Hop Count field of the
IPv6 header for outgoing IPv6 packets. The hops value applies to the
router for which you are displaying information and should be followed
by IPv6 hosts attached to the router. A value of 0 indicates that the
router leaves this field unspecified.
The amount of time (in seconds) that the router is useful as the default
router.
The amount of time (in milliseconds) that a router assumes a neighbor is
reachable after receiving a reachability confirmation. The reachable
time value applies to the router for which you are displaying information
and should be followed by IPv6 hosts attached to the router. A value of 0
indicates that the router leaves this field unspecified.
The amount of time (in milliseconds) between retransmissions of
neighbor solicitation messages. The retransmit time value applies to the
router for which you are displaying information and should be followed
by IPv6 hosts attached to the router. A value of 0 indicates that the
router leaves this field unspecified.
192.168.8.186:4933
192.168.182.106:179
192.168.2.119:179
192.168.2.102:179
2000:4::106:8222
ESTABLISHED
ESTABLISHED
SYN-SENT
SYN-SENT
ESTABLISHED (1440)
43
1113